G8 V8-6.0L (2009)
Caution: A special anti-seize compound is used on the oxygen sensor threads. New service sensors should already have the compound applied to
the threads. Coat the threads of a reused sensor with anti-seize compound P/N 5613695 or equivalent.
1. Install the HO2S (2) to the right catalytic converter and tighten to 42 Nm (31 lb ft).
2. Install the right catalytic converter. Refer to Catalytic Converter Replacement - Right Side (V8) (See: Emission Control Systems/Catalytic
Converter/Service and Repair/Catalytic Converter Replacement - Right Side)Catalytic Converter Replacement - Right Side (V6) (See: Emission
Control Systems/Catalytic Converter/Service and Repair/Catalytic Converter Replacement - Right Side).
3. Connect the HO2S electrical connector (1).
4. Lower the vehicle.
5. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (See: Starting and Charging/Battery/Battery
Cable/Service and Repair).