G8 V8-6.0L (2009)
Transmission Position Switch/Sensor: Service and Repair
5L40-E/5L50-E - Automatic Transmission
Manual Shift Shaft Position Switch Replacement
Special Tools
*
J 44767 Seal Installer
*
EN-48536 Frame Support Tool (Engine Lower 65 mm Kit)
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
2. Remove the transmission manual shift shaft nut.
3. Disconnect the shift linkage from the transmission manual shift shaft.
4. Remove the exhaust system. Refer to Exhaust System Replacement (V8 - For Access) (See: Engine, Cooling and Exhaust/Exhaust
System/Service and Repair/Removal and Replacement/Exhaust System Replacement (For Access))Exhaust System Replacement (V8 - Complete)
(See: Engine, Cooling and Exhaust/Exhaust System/Service and Repair/Removal and Replacement/Exhaust System Replacement (Complete)
)Exhaust System Replacement (V6 - For Access) (See: Engine, Cooling and Exhaust/Exhaust System/Service and Repair/Removal and
Replacement/Exhaust System Replacement (For Access))Exhaust System Replacement (V6 - Complete) (See: Engine, Cooling and
Exhaust/Exhaust System/Service and Repair/Removal and Replacement/Exhaust System Replacement (Complete)).
5. Remove the propeller shaft. Refer to Propeller Shaft Replacement (See: Transmission and Drivetrain/Drive/Propeller Shafts, Bearings and
Joints/Drive/Propeller Shaft/Service and Repair/Propeller Shaft Replacement).
Note: The engine mounts must NOT bend or deflect from the vertical position, damage to the mount will occur.
6. Support the power train with a suitable jack or table.