Grand AM L4-144 2.4L DOHC VIN T SFI (1997)
Wheels: Service and Repair
Balancing Tire and Wheel
Balancing
GENERAL INFORMATION
When static balancing, if more than 40 grams (1.0 oz.) are needed, the wheel weights should be split as equal as possible between the inboard and
outboard flanges.
Balancing factory aluminum wheels requires the use of special nylon coated clip-on wheel weights. These weights are designed to fit over the thicker
rim flange of the aluminum wheel and should be installed with a plastic tipped hammer.
Adhesive wheel weights are also available. Use the following procedure to install adhesive wheel weights.
ADHESIVE WHEEL WEIGHT INSTALLATION
1. Clean wheel by sanding to bare aluminum where wheel weight is to be located.
2. Wipe wheel weight attachment area with a mixture of half Isopropyl alcohol and half water. A clean cloth or paper towel must be used for this
operation.
3. Dry the attachment area with hot air. Surface of wheel should be warm to the touch.
4. The adhesive backing on wheel weights must be warmed to room temperature.
5. Remove tape from back of weights. Do not touch the adhesive surface.
6. Apply wheel weight and press on with hand pressure.
7. Secure wheel weight with a 70 - 110 N (16 - 25 lb.) force applied with a roller.
General Information and Precautions
