Grand AM L4-144 2.4L DOHC VIN T SFI (1997)
2. Install the ignition coil and the electronic ignition control module assembly to the engine while carefully aligning the boots to the spark plug
terminals.
NOTE: ICM cover bolts must be installed with the isolator washers with the rubber side facing down.
3. Install the ignition coil and the electronic ignition control module assembly to the cam housing bolts, after coating the threads with P/N 1052080
or equivalent.
4. Install the cam housing bolts and tighten to 22 Nm (16 lb. ft.).
5. Connect the electronic ICM 11 pin harness connector.
6. Connect the negative battery cable.
