pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

Keyless Entry - Intermittently Inoperative/Poor Range|Page 9479 > < Keyless Entry - Intermittently Inoperative/Poor Range|Page 9477
Page 4
background image

12.

Using the J 38788 tool, remove the push-in retainers (2) which retain the rear shelf trim panel to A the seat backrest support.

13.

Remove the rear shelf trim panel.

14.

Remove the trim panel end supports/pad from the left side of the vehicle.

15.

Install the remote control receiver module to the center of the rear panel in the space provided.

16.

Connect the new wiring harness connector to the remote control receiver module.

17.

Locate ground splice pack (G401). It is a black connector about 38 mm (1.5 in) square next to the left rear speaker. Remove the retaining screw
and the CPA from the connector.

18.

Route the black wire of the new harness to left side ground splice pack. Insert the terminal for the black wire into any empty cavity. Re-install the
CPA and retaining screw.

Keyless Entry - Intermittently Inoperative/Poor Range|Page 9479 > < Keyless Entry - Intermittently Inoperative/Poor Range|Page 9477