Grand AM V6-3.4L VIN E (2001)
Front Door Interior Handle: Service and Repair
Door Handle Replacement - Inside
REMOVAL PROCEDURE
1. Remove the door trim panel.
2. Remove the water deflector.
3. Remove the door handle bolt.
4. Slide the handle forward in order to release the handle from the inner door panel.
5. Pull up on the lock rod and the handle rod and rotate the handle in order to remove the rods.
6. Remove the handle from the door.
INSTALLATION PROCEDURE
1. Position the door handle by the door.
2. Install the lock rod and the handle rod.
3. Slide the handle rearward in order to secure the handle to the inner door panel.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the door handle bolt.
Tighten
Tighten the door inside handle bolt to 10 N.m (89 lb in).
5. Install the water reflector.
6. Install the door trim panel.