Grand AM V6-3.4L VIN E (2001)
7. Install the seat back pivot bolt and bushing.
Tighten the pivot bolt to 8 N.m (71 lb in).
8. Install the split/folding rear seat back.
Rear Split Folding Seat Back Replacement
Rear Split Folding Seat Back Replacement
Removal Procedure
Important: The following procedure is for both the right and left rear split folding seat backs.
1. Open the rear compartment lid.
2. Pull the release handles for the rear split folding seat backs.
Fold down the split folding seat backs slightly to release the seat back from the seat back latch.
3. With a flat-bladed tool release the locking mechanism for the inboard pivot bolt at the center pivot support.
Right side shown, left side similar.
4. Lift up the seat back. This will disconnect the inboard pivot bolt from the center pivot support.
5. Slide the seat back towards the center of the vehicle to disconnect the outboard pivot pin from the wheelhouse bracket.
Right side shown, left side similar.
6. Remove the seat back from the vehicle.
Installation Procedure
1. Install the seat back into the vehicle. Align and insert the outboard pivot pin into the wheelhouse bracket.
Right side shown, left side similar.