Grand AM V6-3.4L VIN E (2001)
9. Inspect the following parts for cuts, tears, or deterioration. Replace any damaged parts:
^
The disc brake mounting and hardware. Refer to Disc Brake Mounting and Hardware Inspection-Front.
^
The caliper dust boot. Refer to Brake Caliper Inspection.
10. Inspect the caliper bolts (2) and pins for corrosion or damage. Do not attempt to polish away corrosion. If corrosion is found, use new parts,
including bushings, when installing the caliper.
Installation Procedure
1. Bottom the piston into the caliper bore. Use an old brake pad or wooden block (2) across the face of the piston. Do not damage the piston or the
caliper boot.
2. Install the retainer slides to the caliper bracket.
Important: The wear sensor is on the inner pad. The sensor is positioned at the leading edge (upward) of the pad during forward wheel rotation.