Grand AM V6-3.4L VIN E (2001)
3. Install the rear pads to the caliper bracket.
4. Lubricate the bolts and the bracket boots with GM P/N 18010908 silicone grease or equivalent.
5. Install the caliper. Refer to Brake Caliper Replacement - Rear.
6. Remove the two hand tightened wheel lug nuts retaining the rotor to the hub.
7. Install the tire and wheel assembly.
8. Lower the vehicle.
9. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
10. Slowly release the brake pedal.
11. Wait 15 seconds, then repeat steps 9 and 10 until a firm brake pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
12. Fill the master cylinder reservoir to the proper level. Refer to Master Cylinder Reservoir Filling.
13. Burnish the pads and rotors. Refer to Burnishing Pads and Rotors.
