Grand AM V6-3.4L VIN E (2001)
1. Assemble the NEW copper brake hose gaskets (2) and the brake hose bolt (1) to the brake hose.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the front brake hose-to-caliper bolt (3) to the caliper (4).
^
Tighten the brake hose-to-caliper bolt to 50 Nm (37 ft. lbs.).
3. Remove the rubber cap or plug from the exposed brake pipe fitting end.
4. Position the brake hose (2) into the mounting bracket and install the retaining clip (3).
5. Connect the front brake pipe (1) to the front brake hose (2).
^
Tighten the front brake pipe fitting to 27 Nm (20 ft. lbs.).
6. Visually inspect that the hose does not make contact with any part of the suspension. Check the hoses in extreme right and left turn conditions. If
the hose makes contact, remove the hose and correct the condition.
7. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure).
8. Lower the vehicle. Refer to Vehicle Lifting.