Grand AM V6-3.4L VIN E (2001)
1. Install the insulator and the bracket to the accumulator.
IMPORTANT: You must add refrigerant oil to a NEW accumulator.
2. Add the required amount of new refrigerant oil to a new accumulator. Refer to Refrigerant System Capacities.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the accumulator bracket and bolt to the vehicle.
Tighten
Tighten the accumulator bracket bolt to 10 N.m (89 lb in).
4. Install the condenser hose assembly to the accumulator.
5. Install the evaporator hose assembly to the accumulator.
6. Install the right front fender liner.
7. Lower the vehicle.
8. Recharge the refrigerant system. Refer to Refrigerant Recovery and Recharging.
9. Leak test the fittings of the component using the J 39400-A.