Grand AM V6-3.4L VIN E (2001)
INSTALLATION PROCEDURE
1. Install the bulb(s) to the socket(s), if required.
2. Install the lens to the high mounted stop lamp housing by aiming the tabs on the lens to the housing and press into place until fully seated, if
required.
3. Connect the electrical connector to the high mounted stop lamp.
4. Install the high mounted stop lamp to the rear compartment lid, pressing into place until the retainers hold the housing.
NOTE: Refer to Fastener Notice in Service Precautions.
IMPORTANT: Inspect the gasket to the lens for proper fit while fighting the nuts.