Grand AM V6-3.4L VIN E (2001)
![background image](/pontiac/grand_am/v6-3.4l_vin_e/Page-987004.png)
Tighten the screws to 3 N.m (27 lb in).
4. Connect the IAC electrical connector.
5. Install the canister purge valve.
6. Install the throttle control cable bracket. Refer to Accelerator Controls Cable Bracket Replacement
7. The powertrain control module (PCM) will reset the idle air control valve whenever the ignition is turned ON, then OFF. Turn ON the ignition,
then OFF.
8. Start the engine and allow the engine to reach operating temperature.