Grand AM V6-3.4L VIN E (2001)
4. Install the park/neutral position switch mounting bolts.
^
Tighten the bolts to 24 Nm (118 ft. lbs.).
5. Align the holes with the mounting boss on the transmission. Place the shift control lever in the N (Neutral) position. Do not rotate the switch. The
switch is pinned in the N (Neutral) position. If the switch has been rotated and the pin is broken, adjust the switch.
Important: Ensure that the engine will only start in P (Park) or N (Neutral). Read just the switch if the engine will start in any other position.
6. Connect the negative battery cable.
7. Place the transmission control shifter assembly in the N (Neutral) notch in the detent plate.
8. Loosen the park/neutral position switch attaching bolts.
9. Rotate the switch on the shifter assembly in order to align the service adjustment hole with the carrier tang hole.
10. Insert a 2.34 mm (3/32 in) maximum diameter gauge pin to a depth of 9.0 mm (9/64 in).
^
Tighten the bolts to 24 Nm (18 ft. lbs.).