Grand AM V6-3.4L VIN E (2001)
Accelerator Pedal: Service and Repair
REMOVAL PROCEDURE
1. Remove the left sound insulator.
2. Remove the release cable (1) retainer from the lever assembly.
3. Remove the retaining nuts.
4. Remove the pedal assembly (2).
INSTALLATION PROCEDURE
1. Install the pedal assembly (2) to the cowl.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Reinstall the retaining nuts.
Tighten
Tighten the nuts to 3 N.m (27 lb in).
3. Slip the accelerator cable (1) through the slot in the rod and then install the retainer in the rod, being sure that the retainer is seated.
4. Reinstall the left sound insulator.
5. Inspect for correct opening and closing positions by operating the accelerator pedal. Make sure that the throttle valve reaches a wide-open throttle
position. If not, inspect for a damaged or bent bracket, lever, or other component, or for carpet under the accelerator pedal.