Grand AM V6-3.4L VIN E (2001)
13. Remove the fuel rail attaching bolts.
14. Remove the fuel rail assembly.
15. Remove the injector O-ring seal from the spray tip end of each injector. Discard the seals.
INSTALLATION PROCEDURE
NOTE:
^
Use care when servicing the fuel system components, especially the fuel injector electrical connectors, the fuel injector tips, and the injector
O-rings. Plug the inlet and the outlet ports of the fuel rail in order to prevent contamination.
^
Do not use compressed air to clean the fuel rail assembly as this may damage the fuel rail components.
^
Do not immerse the fuel rail assembly in a solvent bath in order to prevent damage to the fuel rail assembly.
1. Install the fuel rail assembly into the intake manifold. Tilt the rail assembly to install the injectors.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the fuel rail attaching bolts.
Tighten
Tighten the fuel rail attaching bolts to 10 N.m (89 lb in).
