Grand AM V6-3.4L VIN E (2001)
4. Install the boot (3) onto the gear assembly (1) until the boot is seated in the gear assembly groove.
5. Install the boot clamp on the boot (1) using tool J 22610 (2).
6. Crimp the boot clamp (2).
7. Install the tie rod end clamp on the boot using pliers.
8. Install the jam nut to the inner tie rod assembly.
9. Install the outer tie rod to the steering knuckle.
Refer to Tie Rod End Replacement- Outer.
10. Adjust the front toe. Refer to Front Toe Adjustment.
Rack and Pinion Inner Tie Rod Replacement - Off Vehicle
Disassembly Procedure
Notice: Refer to The Rack Must Be Held During Removal Installation of the Inner Tie Rod in Service Precautions.
1. To remove the rack and pinion boot and the breather tube, refer to Rack and Pinion Boot Replacement - Off Vehicle.
Remove the shock dampener (2) from the inner tie rod assembly (5).
2. Slide the shock dampener (2) back on the rack (1).
3. Remove the inner tie rod assembly (5) from the rack assembly (1) as follows:
3.1. Place a wrench on the flats of the rack assembly (3).
3.2. Place another wrench on the fiats of the inner tie rod housing (4).
3.3. Rotate the inner tie rod housing (4) counterclockwise until the inner tie rod (5) separates from the rack (1).
Assembly Procedure
Notice: Refer to The Rack Must Be Held During Removal and Installation of the Inner Tie Rod in Service Precautions.