Grand AM V6-3.4L VIN E (2001)
Stabilizer Link: Service and Repair
Rear
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the rear stabilizer shaft link bolt (3).
3. Remove the rear stabilizer shaft link (2) from the knuckle (1).
4. Remove the link (2) from the stabilizer shaft (4).
Installation Procedure
1. Install the link (2) to the stabilizer shaft (4).
Notice: Refer to Fastener Notice in Service Precautions.
2. Connect the rear stabilizer shaft link (2) to the knuckle (1).
Tighten
Tighten the rear stabilizer shaft link to knuckle bolt (3) to 69 Nm (51 ft. lbs.).
3. Lower the vehicle.