Grand AM V6-3.4L VIN E (2001)
48.
Reinstall the shift tower into the transaxle.
49.
Install the five (5) shift tower to transaxle case retaining bolts. Refer to Figure 8.
Tighten
Tighten the bolts to 25 Nm (18 lb ft).
50.
Verify that the shift tower is in the neutral position by lifting the levers. If the levers move easily, it is in neutral.
51.
Pull the shift cable assemblies out of the housing as far as they will go.
52.
From inside the vehicle, place the shift cables into the retainers. The cable with the white outer casing goes on the left and the black on the right.
Snap the cables into the anchor plate. Do not close the retainers as the cables will need to be adjusted. Refer to Figure 9.
53.
From under the hood, attach the shift cables to the shift tower. The cable with the white outer casing goes to the bottom and the black sheathed
cable to the top.
54.
Reinstall the relay and the air cleaner bracket to the vehicle.