Grand AM V6-3.4L VIN E (2001)
64.
With a straight-bladed screwdriver, gently pull/pry the neutral position U-clip out. Make sure it is locked into position on the shifter between the
indents. Refer to Figure 11.
65.
Test the shifter operation. All the gears should easily engage. Readjust the shifter cables as required.
66.
Reconnect the BTSI cable to the shifter. Lock the cable into the cable bracket.
67.
Place the console into the proper position and install the two (2) nuts to the studs on the inside front of the console.
Tighten
Tighten the nuts to 2 Nm (18 lb in).
68.
Reinstall the four (4) side console bolts.
Tighten
Tighten the bolts to 2 Nm (18 lb in).
69.
Reinstall the two (2) bolts into the rear console bin.
Tighten
Tighten the bolts to 7 Nm (61 lb in).
70.
Complete the reinstallation of the remaining console components.
71.
Close and snap the shifter boot around the shifter handle.