Grand Prix V6-191 3.1L (1989)
PREPARE PROTECTIVE SHIELDS:
1.
Place each template on the clear protective film (3M P/N 8598 High Performance Film or equivalent) with respect to the desired side of the
vehicle.
2.
Trace around the templates, then, cut out shields using a sharp blade or scissors.
CLEAN SURFACES (FIGURE 1)
1.
Indicated areas of lower bodyside moldings. Use a lint-free cloth soaked in a solution of mild liquid detergent and water.
2.
Rinse with clear water. Wipe dry with lint-free cloth.
3.
Indicated areas with a lint-free cloth moistened with isopropyl alcohol. Let dry.
APPLY SHIELDS:
1.
Peel the protective backing from the film.
2.
Apply (spray or wipe with a lint-free cloth) a solution of 25 percent isopropyl alcohol and 75 percent water to affected area.
NOTICE:
3M recommends using alcohol and water. If an equivalent film is used, check manufacturer's directions.
3.
Wipe or spray the affected area again if it has dried, as the solution provides lubricity for the patch to allow movement before final placement.
Observing locating directions on the template, apply each shield to it's respective area. (Figure 1)
4.
Using your fingers or a small decal applicator (squeegee), work out bubbles and the alcohol/water solution.
Technical Service Bulletin # 891014
Date: 890401
Paint - Rubbing Off Top Inner Door
Bulletin Number:
89-10-14
Reference Number:
931006
Publish Date:
4/89
DOOR PAINT RUB-OFF SERVICE PROCEDURE
Subject:
(INSTALLATION CLEAR URETHANE ADHESIVE FILM)
Models
Affected:
1988-89 PONTIAC GRAND PRIX
Customers may comment about paint rubbing off the top inner portion of the door where it may come in contact with the body lock pillar applique. The
following procedure can be used to repair this condition:
1.
Remove body lock pillar applique, if damaged.
2.
Color coat applique and door (damaged portion) if required.
3.
Install body lock pillar applique.