Grand Prix V6-191 3.1L VIN M SFI (1998)
5. Install the piston and the boot into the bore of the caliper. Push the piston to the bottom of the bore.
6. Seat the caliper boot in the caliper housing (1) counterbore using J 36349
7. Install the caliper.
Brake Caliper Overhaul (Rear)
REMOVAL PROCEDURE
1. Remove the caliper. Refer to Brake Caliper Replacement (Front).
CAUTION: The bolts which attach caliper bracket to knuckles must be replaced anytime they become loose or are removed. In this application,
tightening or loosening these special bolts which use an encapsulated thread compound, is not recommended. Failure to replace caliper bracket
bolts after they have been loosened or removed may result in loosening of caliper to knuckle attachment, causing reduced vehicle braking ability,
and may result in personal injury.
2. Remove the caliper bracket bolts (2).
3. Remove the caliper bracket (1).