Grand Prix V6-191 3.1L VIN M SFI (1998)
1. If removed, install the coolant pump to the engine front cover. Refer to Water Pump Replacement in Cooling System.
2. If removed, install the Crankshaft Position Sensor (CKP) to the engine front cover. Refer to CKP Replacement (24X CKP Sensor) in Powertrain
Management.
3. If removed, install the drive belt shield.
4. Install the drive belt shield bolt.
^
Tighten the drive belt shield bolt to 10 Nm (89 inch lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
5. Coat both sides of the lower tabs of the engine front cover gasket with sealant GM P/N 1052080 or equivalent.