Grand Prix V6-191 3.1L VIN M SFI (1998)
NOTICE: Set steering shah so block tooth on upper steering shaft is at the 12 o'clock position, wheels on vehicle are straight ahead and set
ignition switch to LOCK position. Failure to follow these procedures could result in damage to the SIR coil.
11. Position plastic cover and intermediate steering shaft lower bolt.
12. New rear frame bolts/screws.
13. Lower vehicle.
14. Reservoir inlet hose to pump.
-
Tighten reservoir inlet hose fitting to 27 Nm (20 ft. lbs.).
15. Tie straps to hose.
16. Engine mount strut at engine. Refer to ENGINE MOUNT REPLACEMENT in ENGINE.
17. Fill power steering pump reservoir with fluid.
18. Bleed system. Refer to BLEEDING POWER STEERING SYSTEM. See: Steering and Suspension/Steering/Service and Repair
Inspect
-
For leaks. Refer to STEERING TESTING AND INSPECTION PROCEDURES.