Grand Prix V6-191 3.1L VIN M SFI (1998)
Control Module HVAC: Service and Repair
Remove or Disconnect
1. Right side instrument panel insulator.
2. Electrical connectors from blower motor control module.
3. Loosen (do not remove) both forward mounting screws.
^
Blower motor control module opening is slotted as access is extremely limited.
4. Rearward mounting screw.
5. Blower control module.
Important
^
Care must be taken when removing the blower motor control module. The resistor is a ceramic card for (C60).
Install or Connect
1. Blower motor control module.
2. Rearward mounting screw.
Tighten
^
Screw to 1.5 N.m (13 lb. in.).
3. Tighten both forward mounting screws.
Tighten
^
Screws to 1.5 N.m (13 lb. in.).
4. Electrical connectors to blower motor control module.
5. Right side instrument panel insulator.