Grand Prix V6-191 3.1L VIN M SFI (1998)
Starter Motor: Service and Repair
Starter Motor Replacement
REMOVAL PROCEDURE
CAUTION:
-
Before servicing any electrical component, the ignition key must be in the OFF or LOCK position and all electrical loads must be OFF,
unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal,
also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or
its components.
-
This vehicle has a Supplemental Inflatable Restraint (SIR) System. Refer to SIR Component Views in order to determine whether you are
performing service on or near the SIR components or the SIR wiring. When you are performing service on or near the SIR components
or the SIR wiring, refer to Repair Instructions in SIR. Failure to follow the CAUTIONS could cause air bag deployment, personal injury,
or unnecessary SIR system repairs.
IMPORTANT: The starter motor on this vehicle is not serviceable and must be replaced as a complete unit.
1. Disconnect the battery ground (negative) cable.
2. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
3. Remove the electrical connections at the starter motor. 3100 shown.
4. Remove the torque converter cover.
5. Remove the starter bolts. Remove the shims, if necessary.
INSTALLATION PROCEDURE