Grand Prix V6-191 3.1L VIN M SFI (1998)
Stabilizer Link: Service and Repair
Rear Suspension
REMOVAL PROCEDURE
1. Raise and support the vehicle.
2. Disconnect the rear stabilizer shaft link from the strut.
3. Remove the rear stabilizer shaft link nut.
4. Remove the stabilizer shaft link (2) from the stabilizer shaft (3).
INSTALLATION PROCEDURE
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application.
The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require
thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors)
on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may
damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you
avoid damage to parts and systems.
1. Install the stabilizer shaft link (2) to the stabilizer shaft (3).
-
Tighten the stabilizer shaft link nut to 35 Nm (26 ft. lbs.).
2. Connect the stabilizer shaft-link to the strut.
-
Tighten the stabilizer shaft link to strut bolt/screw to 35 Nm (26 ft. lbs.).
3. Lower the vehicle.