Grand Prix V6-191 3.1L VIN M SFI (1998)
8. Inspect all components for wear and/or damage.
INSTALLATION PROCEDURE
1. Install the rear spring lower insulator (3). Ensure the lower spring is visible between the step and the location mark on the insulator.
2. Install the rear suspension spring.
3. Install the dust shield to the lower insulator.
4. Jounce on the bumper.
5. Install the strut mount.
6. Align the strut shaft with the J 35668.
7. Use the J 34013-B and the J 34013-125 to compress the strut.
8. Pull the strut shaft through the strut mount.
9. Remove the J 35668.
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
10. Use the J 35669 to install the strut shaft washer and to install the strut shaft nut.
-
Tighten the nut to 75 Nm (55 ft. lbs.).
11. Install the strut to the vehicle. Refer to STRUT DISASSEMBLE/ASSEMBLE REPAIR.
