Grand Prix V6-191 3.1L VIN M SFI (1998)
Band Apply Servo: Service and Repair
Forward Servo Replacement
REMOVAL PROCEDURE
Tools Required
^
J 28467-A Engine Support Fixture
^
J 28467-90 Engine Support Adapter
^
J 36462 Support Adapter Leg Set
1. Install the J28467-A.
2. Install the J28467-90.
3. Install the J 36462.
4. Raise and support the vehicle.
5. Remove the power steering gear and hang the power steering gear from the exhaust pipe.
6. Remove the transaxle mount lower bolts.
7. Remove the engine mount lower bolts.
8. Remove the power steering lines from the right side of the frame.
9. Support the rear of the frame with a jackstand.
10. Loosen the front frame bolts.
11. Adjust the jackstand to lower the rear of the frame.
12. Position a drain pan under the forward servo cover.
13. Remove the bolts attaching the servo cover to the transaxle case.
14. Remove the forward servo cover.
15. Remove the forward servo cover O-ring.
16. Remove the servo piston assembly.
17. Remove the servo spring.
INSTALLATION PROCEDURE
1. Install the servo spring.
2. Install the servo piston assembly.
3. Install the forward servo cover O-ring.
4. Install the forward servo cover.
5. Install the forward servo cover attaching bolts.
^
Tighten the forward servo cover attaching bolts to 11 Nm (97 inch lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
6. Remove the drain pan from under the forward servo cover.
7. Adjust the jackstand to raise the rear of the frame.
8. Install the frame bolts.