Grand Prix V6-3.1L VIN J (2000)
2. Install the following components into the caliper bracket (2):
^
The bolt boots (1)
^
The bushings
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the caliper bracket with the bracket bolts.
^
Tighten the caliper bolts to 185 Nm (137 ft. lbs.).
4. Install the caliper. Refer to Brake Caliper Replacement - Front.
Brake Caliper Bracket Replacement - Rear
Removal Procedure
Important: Do not disconnect the brake hose from the caliper. Support or hang the caliper. Do not let the caliper hang from the brake hose.
1. Remove the caliper. Refer to Brake Caliper Replacement - Rear.
2. Remove the caliper bracket bolts.
3. Remove the caliper bracket.
4. Remove the boots from the bracket.
5. Inspect the bracket for cracks. Replace if necessary.
Installation Procedure
Important: Apply a few drops of LOCTITE (R) GM P/N 12345382 (or equivalent) to the threads of the mounting bolt before installing.
1. Lubricate the new bolt boots with silicone grease.
2. Install the bolt boots into the caliper bracket.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the caliper bracket with the bracket bolts.
^
Tighten the caliper bracket bolts to 125 Nm (92 ft. lbs.).
4. Install the caliper. Refer to Brake Caliper Replacement - Rear.
