Grand Prix V6-3.1L VIN J (2000)
3. If equipped with ABS/TCS, install two wave springs (1) between the EBTCM and BPMV. Use locations and orientation noted during removal.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the EBTCM (1) to the BPMV (5).
^
Tighten the top four mounting screws (2) to 2.9 Nm (26 inch lbs.). Tighten screws in an X pattern.
^
Tighten the bottom two mounting screws (2) to 2.9 Nm (26 inch lbs.).
5. Connect the pump motor connector (3) to the bottom of the EBTCM.
6. Connect the EBTCM harness connector. Push in lock tab (1).
7. Turn the ignition switch to the RUN position, engine off.
8. Perform the A Diagnostic System Check - ABS.
