Grand Prix V6-3.1L VIN J (2000)
Windshield Moulding / Trim: Service and Repair
Windshield Reveal Molding Replacement
Removal Procedure
Important:
*
The windshield reveal molding cannot be replaced without removing the windshield.
*
The original windshield molding cannot be reused.
*
Pre-fit the service molding and the windshield to the body as an assembly prior to the actual installation.
*
The new windshield reveal moldings are primed and will adhere to the urethane adhesive.
*
Use a heat lamp in order to make the windshield reveal molding more pliable.
1. Using a flat-bladed tool, carefully pry out the end of the windshield reveal molding approximately 75 mm (3 in).
2. Grasp the windshield reveal molding.
Slowly pull the windshield reveal molding away from the body.
3. Remove the windshield. Refer to Windshield Replacement (See: Service and Repair) .
Installation Procedure
1. Wipe the windshield reveal molding area with a clean, dampened cloth using GM Window Cleaner GM P/N 1050427 or isopropyl alcohol in
order to clean the surface for the installation of the new windshield reveal molding.
Allow to air dry.
2. Prefit the new service windshield reveal molding by locating on the body prior to actual installation.
3. Start from the center and hand press the windshield reveal molding into place.
4. Tape the molding to keep it flush with the windshield, if necessary.
5. Dry fit the windshield, with the reveal molding installed, to the body prior to actual installation.
6. Install the windshield. Refer to Windshield Replacement (See: Service and Repair) .
