Grand Prix V6-3.1L VIN J (2000)
Washer Fluid Level Switch: Customer Interest
Wingshield Washer Solvent Reservoir - Leaking
Bulletin No.:
00-08-43-002
File In Section:
08 - Body and Accessories
Date:
February, 2000
Subject:
Leaking Windshield Washer Solvent Reservoir (Replace Solvent Level Switch)
Models:
2000 Buick Century, Regal
2000 Oldsmobile Intrigue
2000 Pontiac Grand Prix
Condition
Some customers may comment that there is windshield washer solvent leaking from the underhood washer reservoir area.
Cause
The low windshield washer solvent level switch, located in the washer reservoir, may be leaking.
Correction
Inspect the low washer solvent level switch for leaks in the area between the top of the switch and the reservoir seal. If the leak is occurring at this
location install a new low washer solvent level switch and seal assembly using the following service procedure. For additional information, see the
Wipers/Washer Systems sub-section of Body and Accessories in the appropriate Service Manual.
1.
Open the hood and remove the screw attaching the washer reservoir extension (neck) to the inner fender.
2.
Remove the bolt securing the filler tube neck and remove the filler tube neck from the reservoir.
3.
Remove the right headlamp assembly and remove the bolt attaching the upper part of the reservoir to the body.
4.
Raise the vehicle on a hoist and remove the right front tire/wheel.
5.
Remove the screws attaching the front of the wheel house plastic liner to the fender.
6.
Remove the screws attaching the front of the wheel house liner to the fascia.
7.
Remove the screw attaching the front tab on the wheel house liner to the side rail.
8.
Reposition the wheel house liner to access the washer reservoir.
9.
Remove the bolts attaching the washer reservoir and bracket to the body.
10.
Disconnect the electrical connectors from the washer pump and the solvent level switch.
11.
Disconnect the washer hose and remove the reservoir and bracket from the vehicle.
12.
Remove the washer solvent level switch from the reservoir.
13.
Remove the new seal from the new switch and install in the reservoir opening.
14.
Lubricate the opening in the seal with windshield washer solvent.
15.
Install the switch in the seal/reservoir.
16.
Connect the washer hose and the electrical connectors to the washer pump and the solvent level switch.
