Grand Prix V6-3.8L (2007)
3. Remove the screws retaining the air temperature actuator (2).
4. Disconnect the electrical connector from the air temperature actuator.
5. Remove the air temperature actuator from the HVAC Module Assembly.
Installation Procedure
1. Position the air temperature actuator (2). Align the slots in the electric actuator driver to the flats on the shaft.
2. Align the locating hole to the alignment pin on the HVAC module case.
3. Slide the actuator driver on the shaft. The actuator driver should sit completely on the shaft and the mounting holes should be flush with the
HVAC module case.
Notice: Refer to Fastener Notice.
4. Install the screws to the air temperature actuator.
Tighten the screw to 1.5 N.m (13 lb in).
5. Connect the electrical connector to the air temperature actuator.
6. Install the I/P compartment.
7. Install the right side I/P insulator.
8. Calibrate the actuator. Refer to Re-Calibrating Actuators. See: Testing and Inspection/Programming and Relearning
Mode Actuator Replacement
Mode Actuator Replacement
Removal Procedure