Grand Prix V6-3.8L SC VIN 1 (1997)
Wheel Fastener: Service and Repair
Rear Suspension
^
Tool Required:
-
J 6627-A Wheel Bolt Remover
-
Or Equivalent
REMOVE OR DISCONNECT
1. Raise vehicle and suitably support.
2. Tire and wheel.
3. Caliper and rotor.
4. Using J 6627-A extract bolt from hub.
^
Clean wheel hub flange and rotor of any corrosion, metal chips or foreign material.
INSTALL OR CONNECT
1. Replacement bolt in wheel hub.
2. Add enough washers to draw bolt into hub.
3. Wheel nut (flat side to washers).
^
Tighten wheel nut until wheel bolt head seats against hub flange.
Important: Make sure that wheel bolt is fully seated against hub flange.
4. Back off wheel nut and remove washers.
5. Caliper and rotor.
6. Tire and wheel.
7. Lower vehicle.