Grand Prix V6-3.8L VIN 2 (2004)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Brake Pressure Modulator Valve (BPMV) Bracket Replacement
Brake Pressure Modulator Valve (BPMV) Bracket Replacement
Removal Procedure
Caution:
Refer to Brake Fluid Irritant Caution in Service Precautions.
Notice:
Refer to Brake Fluid Effects on Paint and Electrical Components in Service Precautions.
See: Service Precautions/Vehicle Damage Warnings/Brake Fluid Effects on Paint and Electrical Components Notice
1. Turn the Ignition switch to the OFF position.
2. Remove BPMV and EBCM as an assembly from the BPMV bracket. Refer to Brake Pressure Modulator Valve (BPMV) Replacement.
3. Remove the 3 BPMV bracket nuts (1) (2l and (3) attaching the BPMV bracket (4) to the wheel housing.
4. Remove the BPMV bracket (4) from the vehicle.
Installation Procedure
1. Install the BPMV bracket (4) to the wheel house.
Notice:
Refer to Fastener Notice in Service Precautions.
See: Service Precautions/Vehicle Damage Warnings/Fastener Notice
2. Install the 3 BPMV bracket nuts (1) (2) and (3) to the studs on the BPMV bracket (4).
*
Tighten the 3 BPMV bracket nuts to 10 Nm (7 ft. lbs.).
3. Install the BPMV and EBCM as an assembly to the BPMV bracket. Refer to Brake Pressure Modulator Valve (BPMV) Replacement.
4. Turn the ignition switch to the RUN position.
5. Perform the Diagnostic System Check - ABS.