Grand Prix V6-3.8L VIN 2 (2004)
1. Align the I/P passenger knee bolster the I/P carrier (cross car beam).
Inboard bolster shown, outboard bolster similar.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Start the bolts by hand to avoid cross threading. Install the I/P passenger knee bolster bolts.
Tighten
Tighten the bolts to 10 N.m (89 lb.in).
3. Outboard bolster only. Connect the wiring harness retainers (1, 2) to the I/P passenger knee bolster.
4. Outboard bolster only. Install the I/P accessory wiring junction block.
5. Install the I/P trim pad.