Grand Prix V6-3.8L VIN K (1998)
6. Remove the hose bolt attaching the inlet fitting.
7. Plug the openings in the caliper housing (15) and the pipe in order to prevent brake fluid loss and contamination.
8. Remove the caliper bolts (1 and 3).
NOTICE: Do not allow calipers to hang from the flexible hoses. Doing so can damage the hoses.
9. Remove the caliper housing (3) from the rotor (4) and the caliper bracket (1).
10. Inspect the piston boots for the following conditions:
10.1.Cuts
10.2.Tears
10.3.Deterioration
Replace the piston boots if damage exists.
11. Inspect the caliper bracket boots for the following conditions:
11.1.Cuts
11.2.Tears
11.3.Deterioration
Replace the caliper bracket boots if damage exists.
12. Inspect the caliper bolts (2) for corrosion or damage. If corrosion is found, use new parts, including bushings, when installing caliper. Do not
attempt to polish away corrosion.
INSTALLATION PROCEDURE
1. Install the caliper (3) over the rotor (4) and the caliper bracket (1). Ensure that the bushings are in place.
2. Lubricate the caliper bolts (1 and 3). Use silicone grease. Do not lubricate the threads.
3. Lubricate the two rubber boots (13 and 4) in the caliper bracket (12). Use silicone grease.
NOTICE: Refer to Fastener Notice in Cautions and Notices.