Grand Prix V6-3.8L VIN K (1998)
Shift Cable: Service and Repair
A/T Selector Cable Replacement (New Cable Installation Only)
INSTALLATION PROCEDURE
CAUTION: Refer to Automatic Transaxle Range Selector Cable Caution in Service Precautions.
1. Set the parking brake.
2. Block the wheels.
3. Place the transaxle in the Neutral position.
4. Place the shift control in the Neutral position.
5. Connect each cable section to the following before connecting the two cable sections:
^
To the automatic transaxle range selector lever and shift cable bracket.
^
To the column or the console shift control and retainer or wiring harness clip.
6. Insert the metal end fitting of the shift control cable into the transaxle cable end.
7. Use the molded end fittings to push the metal end fitting of the shift control cable and the transaxle cable end together until the metal post snaps
into place.
8. Depress the adjuster clip once. This mobilizes the adjuster housing toward the transaxle end fitting.
9. Line up the end fittings so they slide together until you feel the parts cam together and lock.
10. Depress the adjuster clip completely. This locks the cable into its adjusted service position.
11. Pull the conduit in the opposite direction to assure full system adjustment of the shift cable.