GTO V8-6.0L VIN U (2005)
2. Install the hood latch striker bolt (6) and it's components to the hood (1).
3. Tighten the hood latch striker bolt to achieve a nominal length of 50 mm (2 in).
Important: Lubricate the end of the hood latch striker bolt with lubricant aerosol GM P/N 12346293, or equivalent.
4. Close the hood by dropping from a height of approximately 300 mm (12 in).
Important: Do not push the hood closed, as damage to the panel surface may occur. If the hood does not close on the first attempt, try
again from a slightly greater height.
5. Verify the height difference between the front of the hood and the fenders.
Notice: Refer to Fastener Notice in Cautions and Notices.
Important: As required, also set the hood adjust bumpers to align the hood height.