GTO V8-6.0L VIN U (2005)
Removal Procedure
1. When replacing or repairing an emblem/nameplate do the following:
*
Use tape to protect the mounting surface during removal.
*
Use tape for alignment marks for installation of the emblem/nameplate.
2. To remove an emblem/nameplate, heat the emblem/nameplate using J 25070 .
3. Apply heat using a circular motion for about 30 seconds.
4. Use a plastic, flat-bladed tool to lift or remove the emblem/nameplate from the panel surface.
Important: If tape is still intact on the molding or panel, do not remove the tape. Clean the tape and the mating surface with adhesive
cleaner. Wipe the tape and the mating surface with a clean, lint free cloth. If the tape is damaged, continue with the replacement
procedure.
5. Apply the adhesive foam tape to the back of the emblem/nameplate and press the emblem/nameplate in place.
6. When replacing, remove all adhesive as follows:
*
For body panels, use a 3M(TM) Scotch Brite molding adhesive remover disk 3M(TM) P/N 07502 or equivalent.
*
For plastic panels, use a lint free cloth and Varnish Makers and Painters (VMP) naphtha or a 50/50 mixture by volume of isopropyl alcohol
and water to remove the adhesive.
Installation Procedure
Important: Apply the emblem/nameplate in an environment that is free from dust or other dirt that could come into contact with the
sticky backing. Foreign material may cause improper adhesion.