GTO V8-6.0L VIN U (2005)
7. Measure the oil pan surface flatness, front cover-to-engine block.
0. Place a straight edge across the engine block and front cover oil pan sealing surfaces. Avoid contact with the portion of the gasket that
protrudes into the oil pan surface.
1. Insert a feeler gage between the front cover and the straight edge tool. The cover must be flush with the oil pan surface, or no greater than 0.5
mm (0.02 in) (a) below flush.
8. If the front cover-to-engine block oil pan surface alignment is not within specifications, repeat the cover alignment procedure.
9. If the correct front cover-to-engine block alignment cannot be obtained, replace the front cover.
10. Inspect the camshaft position sensor O-ring seal (704) for cuts or damage. If the seal is not cut or damaged, it may be used again.
11. Lubricate the O-ring seal with clean engine oil.
12. Install the O-ring seal onto the sensor (703).
13. Install the sensor to the cover.
14. Install the camshaft position sensor wire harness (737) and bolts (705, 738).
Tighten the bolts to 12 Nm (106 inch lbs.).
15. Install the oil pan.