GTO V8-6.0L VIN U (2005)
1. Install the fog lamp bulb (3) into the correct locating notches in the reflector and insert the spring retainer (2).
2. Connect the bulb lead (4) to the wiring harness connector inside the sheath (6).
3. Install the lens and reflector assembly (1) into the housing (5), ensuring that the tabs on the rim of the lens and reflector assembly (1) correspond
with the cut-outs in the rim of the housing (5).
4. Position the clamp ring (4) to the fog lamp (2).
5. Install the screw (1) to the clamp ring (4).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screw to 1 N.m(9 lb in)
6. Lower the vehicle.
7. Aim fog lamps, if required. Refer to Fog Lamp Aiming Procedure .
8. Install the lower grille.