GTO V8-6.0L VIN U (2005)
Wheel Bearing: Service and Repair
Wheel Bearing/Hub Replacement - Rear
Wheel Bearing/Hub Replacement - Rear
Tools Required
^
J22912-01 Split Plate Bearing Puller
^
J23444-A Extreme Press Lubricant 1/4 Ounce Tube
^
J-42094-A Wheel Hub Remover and Installer
Removal Procedure
1. Remove the rear suspension lower control arm from the vehicle.
2. From the J-42094-A kit, align the holes in the J-42094-2 (4) with the holes in the rear wheel drive shaft flange.
3. Align the holes in the J-42094-1-B (3) marked "B" with the holes in the J-42094-2 and the holes in the flange.
4. Install the outer constant velocity joint bolts (2) in order to retain the J-42094-2 and the J-42094-1-B to the flange.
5. Unstake the hub nut retainer (5).
6. Use a vise in order to hold the J-42094-1-B (1).
7. Remove and discard the hub nut retainer.
8. Remove and discard the hub nut.
9. Remove the J-42094-1-B from the vise, but leave the tools on the assembly.