J2000/Sunbird V6-191 3.1L (1992)
5B.
To correct center rail weatherstrip to rear rail weatherstrip rolling, use the following procedure:
1.
Lower convertible top about halfway.
2.
Lower quarter window.
3.
Remove center rail weatherstrip retaining screw. Refer to Figure 11.
4.
Remove approximately 100 mm (4.0 inch) of weatherstrip from front to center of retainer.
5.
Apply black weatherstrip adhesive, P/N 12345097, or equivalent, in retainer.
6.
Install center rail weatherstrip into retainer while pushing weatherstrip rearward 3 - 4 mm (0.118 - 0.157 inch). Refer to Figure 11.
7.
Install center rail weatherstrip retaining screw.
8.
Perform watertest. If waterleak is still existing, proceed to step 9.
9.
Remove center portion of center rail weatherstrip approximately 25 mm (1.0 inch) from retainer ends. Refer to Figure 10.
10.
Apply black weatherstrip adhesive, P/N 12345097, or equivalent, in retainer.
11.
Install center rail weatherstrip into retainer while pushing weatherstrip rearward. Refer to Figure 10.
Parts Information
Parts are currently available from GMSPO.
Warranty Information
For vehicles repaired under warranty, use: Seal, center to rear rail -
Labor Operation
Labor Time
B3110 (Right)
0.3 hr.
B3111 (Left)
0.3 hr.
Seal, side rail weatherstrip
Labor Operation
Labor Time
B3140 (Right)
0.3 hr.
B3141 (Left)
0.3 hr.
Seal, rear rail (rear roof rail weatherstrip) -
Labor Operation
Labor Time
B3150 (Right)
0.3 hr.
B3151 (Left)
0.3 hr.