J2000/Sunbird V6-191 3.1L (1992)
Fig. 11 Exploded View, Power Rack & Pinion Assembly. Front Wheel Fig. 11 Drive Beretta, Calais, Cavalier, Corsica, Grand Am, LeMans, Skyhawk, Skylark & Sunbird
1.
Cut off RH mounting grommet and boot clamps, Fig. 11.
2.
Slide boot retaining bushing bushing from rack and pinion boot.
3.
Slide boot assembly, consisting of rack and pinion boot, boot retaining bushing and center housing cover washers, captured in the rack and pinion
boot, from rack and pinion housing.
4.
Remove insert and rack guide assembly as necessary.
5.
Slide boot retaining bushing from rack and pinion boot.
6.
Slide new boot clamp onto rack and pinion boot.
7.
Insert boot retaining bushing into rack and pinion boot.
8.
Coat inner lip of boot retaining bushing lightly with suitable grease to facilitate assembly, then slide assembly onto housing assembly.
9.
Ensure center housing cover washers are in place on rack and pinion boot.
10.
For ease of assembly, insert inner tie rod bolt through center housing cover washers, insert and rack guide and lightly thread bolt into rod and rack
