Montana AWD V6-3.4L VIN E (2004)
Tighten
Tighten the module thumb screw to a maximum of 0.2 N.m (2 lb in).
4. Connect the cell antenna coaxial cable to the VCIM.
5. Install the upper trim pad.
6. Install the windshield garnish molding.
IMPORTANT: After replacing the vehicle communication interface module, you must configure the OnStar(R) system. Failure to configure the
system will result in an additional customer visit for repair. In addition, pressing and holding the white dot button on the keypad will NOT reset this
version of the OnStar(R) system. This action will cause a DTC to set.
7. Reconfigure the OnStar(R) system. Refer to OnStar Reconfiguration. See: Testing and Inspection/Programming and Relearning
