Montana AWD V6-3.4L VIN E (2004)
Power Steering Pump: Service and Repair
Power Steering Pulley Replacement
Power Steering Pulley Replacement
Tools Required
^
J 37609-A Power Steering Pump Pulley Remover
^
J 25033-C Pulley Installer
Removal Procedure
1. Remove the drive belt.
2. Remove the power steering hoses from the power steering hose retainers.
Important: Do NOT disconnect the power steering hoses from the power steering pump.
3. Remove the power steering pump from the engine for clearance.
4. Use J 37609-A in order to remove the pump pulley.
Installation Procedure
Important:
^
Ensure that the face of the pulley hub is flush with the end of the pump shaft.
^
Do not use the arbor press to install the pulley.
1. Use J 25033-C in order to install the power steering pump pulley.
2. Install the power steering pump to the engine.
