Montana AWD V6-3.4L VIN E (2004)
2. Install the case extension housing (6) with the axle seal and with the O-ring (8).
Notice: Refer to Fastener Notice in Service and Precautions.
3. Install the case extension housing bolts (5).
Tighten the bolts (5) to 36 Nm (27 ft. lbs.).
4. Install the vehicle speed sensor. Refer to Input Speed Sensor Replacement.
5. Install the transaxle brace. Refer to Automatic Transmission Brace Replacement.
6. Connect the right drive axle to the transaxle. Refer to Wheel Drive Shaft Replacement - Front.
7. Lower the vehicle.
Notice: Do NOT overfill the transaxle. The overfilling of the transaxle causes foaming, loss of fluid, shift complaints, and possible damage to the
transaxle.
8. Adjust the fluid level. Refer to the following information.
^
Transmission Fluid Checking Procedure See: Transmission Control Systems/Testing and Inspection/Component Tests and General Diagnostics
^
Fluid and Lubricant Recommendations
^
Capacities - Approximate Fluid See: Testing and Inspection
9. Inspect for completion of the repairs.
10. Inspect for fluid leaks.
