Montana AWD V6-3.4L VIN E (2004)
Shifter A/T: Service and Repair
Shift Lever Replacement
Removal Procedure
Caution: Refer to SIR Caution in Service Precautions.
1. Disable the SIR system.
2. Slide the shift lever seal (2) up the shift lever (4).
3. If necessary, remove the steering column trim covers.
4. Disconnect the shift lever connector at the base of the column.
5. Remove the shift lever screw (3) from the shift lever assembly (4).
6. Remove the shift lever and seal from the column.
Important: The shift lever seal must be removed by sliding the shift lever seal towards the narrow section of the shift lever.
7. Remove the shift lever seal (2) from the shift lever (4).
Installation Procedure
Important: The shift lever seal must be installed to the narrow end of the shift lever.
1. Install the shift lever seal (2) onto the shift lever assembly (4).
2. Install the shift lever assembly (4).